KITCHENAID 5KSM150PS - Manual (Page 34)

English
13
Attachments and Accessories
To Attach
1. Turn speed control to “O”.
2. Unplug Stand Mixer or disconnect
power.
3. Loosen attachment knob by turning it
counterclockwise.
4. Remove attachment hub cover.
5. Insert attachment shaft housing into
attachment hub, making certain that
attachment power shaft fits into
square attachment hub socket. It may
be necessary to rotate attachment
back and forth. When attachment
is in proper position, the pin on the
attachment will fit into the notch on
the hub rim.
6. Tighten attachment knob by turning
clockwise until attachment is
completely secured to Stand Mixer.
7. Plug into proper electrical outlet.
To Remove
1. Turn speed control to “O”.
2. Unplug Stand Mixer or disconnect
power.
3. Loosen attachment knob by turning it
counterclockwise. Rotate attachment
slightly back and forth while pulling
out.
4. Replace attachment hub cover.
Tighten attachment knob by turning it
clockwise.
General Information
KitchenAid ® Attachments are designed to assure long life. The attachment power shaft
and hub socket are of a square design, to eliminate any possibility of slipping during
the transmission of power to the attachment. The hub and shaft housing are tapered to
assure a snug fit, even after prolonged use and wear. KitchenAid
® Attachments require
no extra power unit to operate them; the power unit is built-in.
‡Not part of mixer.
General Instructions
Attachment
Hub Socket
Attachment
Knob
Notch Pin
Attachment Shaft
Housing
Attachment
Power Shaft‡
Attachment
Housing