KITCHENAID KEMI301G - Manual (Page 36)

36
Starting an operation
After programming a function, you must
press the Start pad to start
the function. If you do not
press START within 5 seconds
of programming, “START?” will show on the
display as a reminder.
Canceling an operation
LOWER OVEN CANCEL will cancel any
lower oven function. When you
press LOWER OVEN
CANCEL, the large display will
not show anything, unless the oven is too
hot after canceling a Self-Cleaning cycle.
NOTE: You may hear a fan blowing in the
oven after you press LOWER OVEN
CANCEL. This is the cooling fan. It will turn
off when the oven has cooled down.
Changing audible signals
Audible signals tell you if a function is
entered correctly or not. They also tell you
when a cycle is completed.
To change pitch and loudness of key tone:
PRESS and hold for 5 seconds
A short tone will sound and “Snd” and “Hi” or
“Lo” will appear on the display. Repeat the
step above to change to the other setting.
To turn on and off oven reminder tones:
PRESS and hold for 5 seconds
To turn on and off timer reminder tones:
PRESS and hold for 5 seconds
To turn on and off key pad entry and
end-of-cycle tones:
PRESS and hold for 5 seconds
A short tone will sound and “Snd” and “ON”
or “OFF” will appear on the display to tell
you the signals have been changed. Repeat
the step above to turn the signals back on.
Using the control lock
The control lock prevents unwanted use of
the oven by disabling the control panel
command pads.
NOTES:
• Control lock is available only when both
the lower oven and the microwave oven
are not in use. It is also not available during
the Self-Cleaning cycle or the Sabbath
mode.
• Control lock does not disable the Timer
or Clock.
• Set control lock when cleaning the control
panel to prevent oven from accidentally
turning on.
To lock or deactivate the control panel:
Press and hold CONTROL LOCK (Number
Pad 3) for 5 seconds. A single
tone will sound and “CONTROL
LOCK ” will appear on the
display.
To unlock the control panel:
Press and hold CONTROL LOCK (Number
Pad 3) for 5 seconds. A single
tone will sound after 5 seconds
and “CONTROL LOCK ” will
disappear from the display.
Prompt for start
If “START?” is lit, this means that START
has not been pressed. If you do not press
START, the programmed function will
automatically be canceled in 5 minutes.
7
COOK
TIME
START
3
CONTROL
LOCK
3
CONTROL
LOCK
U
sing Your Electric Oven
4452303v10c103 8/13/98 5:28 PM Page 36