KITCHENAID KEMI301G - Manual (Page 54)

54
If none of these items was causing your problem, see “Requesting Assistance or Service”.
T
roubleshooting
Most cooking problems often are caused by little things you can find and fix without tools of
any kind. Check the lists below and on the next page before calling for assistance or service.
If you still need help, see “Requesting Assistance or Service” on page 56.
If nothing operates, check the following:
• Is the oven wired into a live circuit with the proper voltage? (See Installation
Instructions.)
• Have you blown a household fuse or tripped a circuit breaker?
Other possible problems and their causes:
CAUSE
• You have not set the electronic control correctly. Refer to the
section in this manual describing the function you are
operating.
• You have programmed a delayed start time. Wait for the
start time to be reached or cancel and reset the control.
• You have programmed a delayed start time. Wait for the
start time to be reached or cancel and reset the control.
• You have set the display not to show the clock time. To
see the clock time again, press and hold CLOCK SET/START
for 5 seconds.
• The oven is not level. (See Installation Instructions.)
• The oven temperature seems too low or too high. See
“Adjusting oven temperature” section.
• You did not preheat the oven before baking (if called for
in recipe).
• You are using a pan that is not the correct type or size. Refer
to a reliable cookbook or recipe for recommended pan type
and size.
• There is not enough air space around pan when baking. Allow
1
1 ⁄
2
to 2 inches (4 to 5 cm) of air space on all sides of pan.
• There has been a power failure. Reset the clock.
• Press LOWER OVEN CANCEL. If the code reappears, note
the code and call for service.
• The Control Lock has been set. Turn off the Control Lock by
pressing and holding CONTROL LOCK (Number Pad 3) for 5
seconds.
• The Sabbath mode has been set (“Sab” appears on the dis-
play). Turn off the Sabbath mode by pressing and holding
Number Pad 6 for 5 seconds.
PROBLEM
The oven will not
operate
The Self-Cleaning
cycle will not
operate
Display is blank
Cooking results
are not what you
expected
The display is
showing “PF”
A letter followed
by a number
shows on the
display (for exam-
ple “E3,” “F1”)
The key pads do
not operate
4452303v10c103 8/13/98 5:29 PM Page 54