KITCHENAID KEMI301G - Manual (Page 12)

12
NOTES:
• If you touch one Command pad and then
want to choose another Command pad in the
same cycle, you must press CANCEL first.
• If you attempt to enter unacceptable
instructions three tones will sound. Touch
CANCEL and re-enter the instructions.
Audible signals
Audible signals are available to guide you
when setting and using your oven:
• A programming tone will sound each
time you touch a pad.
• Four tones signal the end of a cooking
cycle or the Minute Timer countdown.
Choosing cooking function
settings
The cooking functions discussed in the
“Getting to Know Your Microwave Oven” and
“Microwave Cooking” sections use
Command pads to choose cooking function
settings. Another way to choose cooking
function settings is by using Code pads.
Code pads are Number pads used to select
a cook power, food settings, or quantities.
Food setting charts found in the “Using
CUSTOM REHEAT,” “Using CUSTOM
DEFROST,” and “Using CUSTOM COOK”
sections list only Code pads for food set-
tings. The charts in “Using code pads” in the
“Microwave Cooking” section list all the
available Code pads.
Interrupting cooking
You can stop the oven during a cycle by
opening the door. The oven stops heating
and the fan stops, but the light stays on.
To restart cooking for all cycles, close the
door and
TOUCH
If you do not want to continue cooking:
• Close the door and the light goes off
AND
• TOUCH
E ASY M INUTE
START
MICROWAVE OVEN
CANCEL
G
etting to Know Your Microwave Oven
Setting the clock
When your microwave oven is first plugged
in or after a power failure, the colon and time
of day will flash for 5 minutes. “PF” will show
on the lower oven Temperature Display until
any pad is touched.
NOTES:
• You can only set the clock when the lower
oven and the microwave oven are not
cooking food and when the Minute Timer is
not counting down.
• You can clear the time of day from the
Display by touching and holding CLOCK
SET•START for 5 seconds. Touch CLOCK
SET•START to see the time of day again.
To set time:
1. Choose the clock.
2. Enter time of day.
Example for 5:30:
3. Complete entry.
TOUCH
TOUCH
CLOCK
SET START
5
TOUCH
CLOCK
SET START
OR
E ASY M INUTE
START
0
QUANTITY
CONTROL
LOCK
3
4452303v10c103 8/13/98 5:28 PM Page 12