Kenwood DPX-MP4070 EN - Manual (Page 13)

English | 13
Adjustment of Equalizer type at PRO
Adjusting the effect of an Equalizer type selected
in 'Equalizer Control' when 'Equalizer mode' is
"PRO".
1
Refer to 'Equalizer Control' (page 12) to
select the Equalizer type.
2
Select the item for adjustment
Press the [FM+] or [AM–] button.
Each time the button is pressed, the items that
can be adjusted switch as shown below.
3 Adjust the item
Press the [
4] or [¢] button.
Adjustment Item Adjustment Item Display Display Display Range Range
Bass Center Frequency Bass Center Frequency "BasF" 60/70/80/100 or 150 Hz
Bass level "BasLV" –12 — +12
Bass Q Factor "BasQ" 1.00/1.25/1.50/2.00
Bass Extend "EXT" ON/OFF
Middle Center Frequency Middle Center Frequency "MidF" 0.5/1.0/1.5/2.0 kHz
Middle level "MidLV" –12 — +12
Middle Q Factor "MidQ" 1.0/2.0
Treble Center Frequency Treble Center Frequency "TreF" 10.0/12.5/15.0/17.5 kHz
Treble level "TreLV" –12 — +12
• According to the Bass Q Factor setting value, the
frequencies that can be set in Bass Center Frequency
change as shown below.
Bass Q Factor Bass Center Frequency Bass Center Frequency Bass Center Frequency
1.00/1.25/1.50 60/70/80/100
2.00 60/70/80/150
• When the Bass Extend is set to ON, low frequency
response is extended by 20%.
4 Exit the Equalizer Control mode
Press the [EQ] button for at least 1 second.
When operation stops for 10 seconds, the
Equalizer type at that time is registered and the
Equalizer Control mode automatically closes.
Memory preset of adjustment of
Equalizer type
The 'Adjustment of Equalizer type at PRO' can be
preset.
1
Refer to 'Adjustment of Equalizer type at
PRO' (page 13) to adjust the Equalizer type.
2 Preset the adjusted value
Press the [1] — [3] button for at least 1
second.
Recalling a setting value
1 Enter the Equalizer Control mode
Press the [EQ] button.
"EQ PRO" is displayed.
• If "EQ EASY" is displayed, refer to 'Equalizer mode'
(page 25) to set the mode to "EQ PRO".
2
Recall the setting value
Press the [1] — [3] button.