Konica Minolta 140 - Manual (Page 20)

39 38
FOCUS-AREA INDICATOR CONTROLS
The display of the focus-area indicator can be controlled with a custom function.
CUSt-1:1 - The focus-area indicator automatically appears when looking through
the viewfinder.
CUSt-1:2 - The focus-area indicator appears when the shutter-release button is
pressed partway down.
CUSt-1:3 - The focus-area indicator is canceled and will not be displayed.
1. Press and hold the AF mode button for
about two seconds until “CUSt-1” appears
on the top of the data panel.
• The number blinking in the frame-counter area is the
current custom setting. The initial setting is CUSt 1:1.
2. To change the setting, press the adjust
button or zoom lever until the desired
setting number is displayed.
ADVANCED OPERATION
3. Press the AF mode button once to enter the new setting.
• The camera will return to the shooting mode automatically after five seconds.
Pressing the AF mode button again or pressing the shutter-release button
partwary down will also return the camera to the shooting mode.
• The new custom setting will remain in effect even if the camera is turned off or
the battery is changed.