Kenwood TK-2200 - Manual (Page 26)

18
C
HANNEL
O
PERATING
F
REQUENCIES
To change the operating frequency of a channel:
2
1
3
1
1
4
With the transceiver power OFF, press
and hold the PTT switch and Lock key
while turning the transceiver power ON.
Continue to hold the PTT switch and Lock
key until the LED lights orange and the
transceiver announces “Self”.
Release the PTT switch and Lock key.
The transceiver announces “Channel”.
Pressing the Lock key or Scan key will toggle between QT,
DQT, and Channel setup.
Press the Lock key to increment the
Table number or the Scan key to
decrement the number, to select the
new channel frequency.
Press and hold the Lock or Scan key to
increment/ decrement the number by
5 at a time.
Table numbers and their corresponding
operating frequencies are provided in the
table on page 19.
A voice announcement will inform you of
the currently selected Table number.
Press and release the PTT switch, then
rotate the Channel selector to your
desired channel.
Upon pressing and releasing the PTT
switch, the transceiver announces
“
Table zero”.
TK-2200/3200 E 01-33-10 04.7.16, 1:44 PM 18