Kenwood TK-2200 - Manual (Page 12)

4
PREPARATION
C
HARGING THE
Ni-MH B
ATTERY
P
ACK
The initial charging of the battery pack after purchase or
extended storage (greater than 2 months) will not bring the
battery pack to its normal operating capacity. After repeating
the charge/discharge cycle 2 or 3 times, the operating
capacity should increase to normal.
◆ Do not recharge the battery pack if it is already fully charged.
Doing so may cause the life of the battery pack to shorten or the
battery pack may be damaged.
◆ After recharging the battery pack, disconnect it from the charger.
Charging the battery pack for more than 5 days may reduce the
battery pack life due to overcharging.
Note:
◆ The ambient temperature should be between 41°F and 104°F
(5°C and 40°C) while charging is in progress. Charging outside
this range may not fully charge the battery.
◆ Always switch OFF the transceiver equipped with a Ni-MH
battery pack before charging. Using the transceiver while
charging its battery pack will interfere with correct charging.
◆ The battery pack life is over when its operating time decreases
even though it is fully and correctly charged. Replace the battery
pack.
TK-2200/3200 E 01-33-10 04.7.16, 1:43 PM 4