Kenwood TK-2200 - Manual (Page 21)

13
KEY FUNCTIONS
L
OCK
K
EY
The default function of the Lock key is Super Lock.
Super Lock is designed to prevent accidental function
changes on your transceiver, during operation.
Press and hold the Lock key for 4 seconds to lock the
transceiver keys. The following keys/ functions can still be
used when Super Lock is active: Calling Alert, Monitor,
Monitor Momentary, PTT, Squelch Off, Squelch Off
Momentary, and Volume.
To deactivate Super Lock, with the transceiver power OFF,
press and hold the Scan key for 2 seconds while turning the
transceiver power ON.
• When the LED lights orange, release the Scan key. A
confirmation tone will sound.
S
CAN
K
EY
The default function of the Scan key is Scan + Temporary
Delete.
You can scan the channels of the transceiver to search for a
signal. When the transceiver verifies a signal on a channel, it
proceeds to check whether or not its QT/ DQT setting
matches that which is set up on your transceiver (if any).
If the QT/ DQT matches, the transceiver stops at the channel
and opens the squelch so you can listen to the call. If the QT/
DQT does not match, the call is ignored and scanning
continues.
Note: You can only use Scan if there are at least 2 channels
available on your transceiver that are not locked out of Scan.
TK-2200/3200 E 01-33-10 04.7.16, 1:44 PM 13