KVH Industries TracVision C3 - Manual (Page 80)

E.7 Debug Commands
Report Offset Angles
Function: reports system offset angles
Command: OFFSETS
OFFSETS,XXXXX,YYYY
Response: Offsets= XXXXX.X XXXXX.X
Where: X = new azimuth offset (-1800 - 1800)
Y = new elevation angle (-450 - 450)
Applies Default Values to Default Satellites
Function: updates the default satellites to the default values
Command: SATPAIR,X
Response: displays numerous frequency commands and
reports “Satellite Installation Complete”
Where: X = 0 (satellites default to Astra1 and Hotbird)
or
X = 1 (satellites default to EchoStar 119 and
Expressvu)
or
X = 2 (satellites default to DSS 101 and DSS 119)
Report Last Satellite Tracked/Update Value
Function: reports the last satellite tracked or updates the last
tracked satellite to the value input if it is different
from the current value
Command: LASTSAT
LASTSAT,X
Response: Last =
Where: X = A (updates to satellite A)
or
X = B (updates to satellite B)
E-9
Maintenance Port Parser Commands
54-0159 Rev. G
Table E-7
Debug Commands