Tracvision c3 owner’s manual addendum, Dish 500 mode, Eco #7173) – KVH Industries TracVision C3 User Manual
Page 4
1
54-0159 Addendum to Rev. G
TracVision C3 Owner’s
Manual Addendum
(ECO #7173)
The following information applies to Revision G of the
TracVision C3 Owner’s Manual (KVH Part Number 54-0159).
Your TracVision C3 system has the capability to automatically switch
between the Echo 119 and Echo 110 satellites in DISH 500 mode.
DISH 500 Mode
When a compatible DISH Network
™
receiver* is connected to the
TracVision antenna’s RF1 connector, and the antenna is
configured for DISH 500 mode, you can switch between the
Echo 119 and Echo 110 satellites using the receiver’s remote
control.
* All new DISH Network receiver models should be compatible with the
TracVision antenna’s DISH 500 mode. The following models have been
proven compatible by KVH: DishPro 301, 311, and 811.
Configuring the Antenna for DISH 500 Mode
To configure the TracVision antenna for DISH 500 mode, you will
need to run the receiver’s Check Switch function twice. You do
not
need a laptop computer.
To configure the TracVision antenna for DISH 500 mode, follow
the steps below.
1. Stop your vessel in a blockage-free area and do not
move the vessel until you have completed the
entire configuration process.
2. Turn on the master receiver (the receiver that is
connected to the antenna’s RF1 connector) and the
television.
3. Turn on the TracVision antenna using the
switchplate’s power switch.
4. Wait one minute for the antenna to initialize.
N E T W O R K