KVH Industries TracVision C3 - Manual (Page 45)

3 Using Your TracVision C3
For TracVision C3 to receive the satellite signals, the antenna
must have a clear line of sight to the satellite. If you only receive
intermittent signals or the antenna cannot find the satellite, check
around your vessel for any objects that could be blocking the
signal, such as other vessels, trees, buildings, other onboard
equipment, etc.
You must also be located within the selected satellite’s coverage
area in order to receive its signal. Refer to your satellite television
service manual to check the viable coverage area. For your
convenience, KVH provides links to several web sites that offer satellite
coverage information. Simply go to our web site at:
www.kvh.com/
footprint/index.html .
3.1 Turning On the System
The TracVision C3 system is easy to use. Antenna unit
initialization and satellite acquisition are completely automatic.
To use the TracVision C3 system:
1. Turn on the IRD and the television. ( Refer to your
IRD user manual for complete operating
instructions for the IRD.)
2. Turn on the antenna using the switchplate, as
pictured in Figure 3-2.
3-1
Using Your TracVision C3
54-0159 Rev. G
To minimize the time it takes the
antenna to acquire the satellite, do
not change the channel during the
startup process or cable unwrap.
Figure 3-1
Be Aware of Objects that Might
Block the Satellite Signals
Antenna
On/Off
Switch
Figure 3-2
Turning on the TracVision C3
Using the Switchplate