Kodak ESP 1.2 - Manual (Page 10)

www.kodak.com/go/aiosupport 5
KODAK ESP 1.2 All-in-One Printer
Configuring printer settings
To set or change basic printer settings:
1. Press .
2. Press to select Printer Settings, then press OK.
3. Press to select one of the following settings:
• Date and Time
– Press OK, then press to select Year, Month, Day, Hour, or Minute.
– Press or to change the values; press OK when you are done making
changes.
– Press to return to the Printer Settings menu.
• Button Sounds
– Press or to toggle the button sounds On or Off . Press OK to save
your selection.
• Time to Low Power
To conserve energy, your printer will enter a low power (sleep) mode after
being idle for a default delay time of 1 hour. You can increase the delay time to
low power. Increasing the delay time may result in reduced energy savings.
– Press to change the time to energy-saving sleep mode (select from 1 to
4 hours in 0.5 hour increments). After the time to low power, the printer
enters a low-power (sleep) mode.
• Tagged Images Printing (see Printing tagged pictures, page 34 )
– Press to select Off or On.
• Language
– Press OK, press to select a language, then press OK.
• Country/Region
– Press OK, press to select a country or region, then press OK.
• Reset All Settings (see Resetting factory defaults, page 74 )
NOTE: Resetting factory defaults does not change the date and time,
language, country/region, or network settings.
• Printer Info
– Press OK to view the Firmware Version number; press OK when you are
done.
4. Press to return to the Main Menu.