Unsupported usb hub, please remove, Unplug and change mode, Waiting – Konftel G510-7276-00 User Manual
Page 102: Waiting, too many events, Waste toner box, 30 toner cart missing, Yy defective cartridge, Yy defective imaging kit
Unsupported USB hub, please remove
Remove the unrecognized USB hub.
Unplug and change mode
Make sure that the camera is in a valid mode for PictBridge
Waiting
The printer has received data to print, but is waiting for an End-of-Job command, a Form Feed command, or additional
data.
Try one or more of the following:
•
Press to print the contents of the buffer.
•
Cancel the current print job.
Waiting, too many events
Wait for the message to clear.
Warning—Potential Damage: Do not turn the printer off while this message appears on the display.
Waste Toner Box
The waste toner bottle is nearly full. Press
to clear the message and continue printing.
30
Insert the missing toner cartridge to clear the message and continue printing. If the message appears again, remove
the cartridge, and then insert it until it clicks into place.
31.yy Defective
Try one or more of the following:
•
Open and close the top cover.
•
Remove the specified toner cartridge, and then insert it until it clicks into place.
•
Turn the printer off, wait ten seconds, and then turn the printer on.
•
Replace the specified toner cartridge with a new one.
31.yy Defective Imaging Kit
Try one or more of the following:
•
Open and close the top cover.
•
Remove the imaging kit, and then insert it until it clicks into place.
•
Turn the printer off, wait ten seconds, and then turn the printer on.
•
Replace the defective imaging kit with a new one.
Understanding printer messages
100