Kenwood HM-V655MP - Manual (Page 27)

Recording on TAPE
27 EN
Pause the recording
÷ Press the rec key during recording. It pause after
leaving a non-recorded blank of 4 seconds. (Press
the key again to resume recording.)
Lights
Stop the recording
Select an input source other than
"TAPE"
Example:
To select the CD input
\ \
\ \
Select the reverse mode. ™
3. Set the recording condition.
÷ Check the tape transport direction before starting recording. If it is set to
the reverse direction ( 2), only one side of tape can be recorded regardless
of the reverse mode setting made here.
÷ The tape equalizer is defeated during recording.
4. Select the source to be recorded.
CD (CD-DA, VIDEO CD with PBC OFF and MP3 file) [For PBC OFF *]
TUNER (Broadcasts)
AUX (External input) [Adjusting the AUX input level r]
÷ If a CD has already
been loaded, it starts to
play now. Press the
7
key to stop it.
The character information display shows the re-
cording input source.
5. Start recording.
1
Press the rec key.
2
Play (or tune) the input source to be recorded.
÷ Recording stops automatically when the tape side(s) to be recorded have
been fully recorded.
1 "BEAT CANCEL ON" :
(Beat Cancel is activated)
2 "BEAT CANCEL OFF" :
(Beat Cancel is deactivated)
Each press switches the modes as follows.
While recording from tuner input, beat sound can be minimised by
pressing the set/demo key.
5281/26-28/EN 6/13/02, 9:36 AM 27