One-by-one presetting, Tuning to a non-preset radio station – Kenwood HM-V655MP User Manual
Page 25
Receiving broadcast station
25
EN
One-by-one presetting
(Manual preset)
1
Select the AUTO or MANUAL mode.
2
Tune a station.
Select the tuning mode according to the radio
wave receiving condition.
When the receiving condition is good:
AUTO mode
When it is poor due to weak radio waves:
MANUAL mode
In AUTO mode :
The next preset station can be received automatically
every time the TUNING (
1 or ¡) key is pressed.
In MANUAL mode :
Press the TUNING (
1 or ¡) key repeatedly until the
desired station is received. The desired station can
also be received by holding the TUNING (
1 or ¡)
key depressed until its frequency is displayed.
To increase
frequency
To decrease
frequency
Each press alternates the mode.
1 "AUTO" :
Stereo reception ("AUTO" lit)
2 "MANUAL" :
Monaural reception ("AUTO" not lit)
1
Perform the procedure in "Tuning to a non-
preset radio station (Auto tuning, Manual
tuning)" to receive the station to be preset.
2
Press the ENTER key during reception.
3
Select one of the preset numbers from
1 to 30.
4
Press the ENTER key again.
÷ In MANUAL mode, FM stations are received in mon-
aural.
÷ Normally, use the AUTO (Auto tuning, stereo recep-
tion) mode.
÷ A maximum of 30 stations of the band presently being
received will be preset.
(Repeat steps
1, 2, 3 and 4 to preset other sta-
tions)
÷ If several stations are preset under the same number,
the previous memory is replaced with the latest
memory contents.
(Proceed to step
3 while "MEMORY" is lit.)
"MEMORY" lights (for approx. 20 sec.)
÷ The same operation is also available with the 7
[Tuning Mode] key on the main unit.
Tuning to a non-preset radio station
(Auto tuning, Manual tuning)
Remote control unit only
AUTO/MONO
STOP/
RETURN
TUNING
Remote control unit only
ENTER
P
R
E
V
.
N
E
X
T
P.CALL
P.CALL
0
8
5
2
9
6
3
7
4
1
10
ENTER
5281/21-25/EN
6/13/02, 9:32 AM
25