Kodak i250 - Manual (Page 67)

A-61167 September 2002 E-3
11. Remove the existing memory card from the main control board.
12. Plug the new SODIMM card into the main control board.
13. Replace the circuit board cover.
14. Secure the circuit board cover with its two screws.
NOTE: If you removed the optional imprinter cable from the imprinter board,
reinstall the cable now. Refer to Appendix C, KODAK i200 Series
Imprinter, for information about the imprinter cable.
15. Lower the scanner door and press it down firmly until it latches into place.
16. Re-attach the scanner’s output tray.
17. Re-attach the IEEE-1394 cable to the IEEE-1394 port on the back of
the scanner.
18. Re-attach the power cord.
SODIMM card