Installing the ink blotter strips – Kodak i250 User Manual
Page 49
C-10
A-61167 September 2002
Installing the
Ink Blotter Strips
Two ink blotter strips in the scanner transport area collect ink overflow.
NOTE: Improperly aligned blotter strips may cause paper jams.
1. Lift up the scanner door release to unlatch the scanner door.
2. Pull up to open the scanner door.
3. Locate the two channels in the rear of the transport area.
These channels are where the blotter strips will be installed.
4. Remove the backing from a new blotter strip.
5. Align the blotter strip in one of the channels.
NOTE: Improperly aligned blotter strips may cause paper jams.
6. Press the adhesive side of the blotter strip down firmly into the channel.
7. Repeat Steps 4-6 for the other strip.
8. Lower the scanner door and press it firmly until it snaps into place.
Channels