Kodak i250 - Manual (Page 45)

C-6 A-61167 September 2002
12. Attach the end of the imprinter cable that has the metal block (ferrite block
end) to the connector in the opening on the circuit board cover.
13. Peel off the backing from the first self-stick hook-and-loop pad that is
attached to the imprinter cable.
14. Align the imprinter cable along the channel in the circuit board cover and
press the first self-stick hook-and-loop pad firmly to attach it to the circuit
board cover.
15. Continue to align the imprinter cable along the channel in the circuit board
cover until it is behind the circuit board cover.