Kodak i250 - Manual (Page 27)

22 A-61167 September 2002
4. Inspect the feed module.
If the tires show signs of wear or damage, replace the feed module.
5. Remove any dust or debris from the tray area under the feed module and
the front roller cover.
6. Insert the feed module by aligning the pins and pushing it toward the right
to fit it into position.
7. Re-install the front roller cover.
8. Go to the next section to clean the drive rollers and transport area.
Cleaning the Drive Rollers
and Transport Area 1. Manually rotate and wipe the drive rollers with a roller cleaning pad.
2. Clean any dust or debris in the slots around the drive rollers.
3. Wipe the upper and lower transport areas with a roller cleaning pad.
4. Dry the transport area with a lint-free cloth.