Kodak A-61557 - Manual (Page 29)

A-61557 December 2006 27
12. Launch the Kodak ScanTest Software.
13. Clean each drive roller by selecting Eject on the Kodak ScanTest
Software window. Selecting Eject will turn the drive rollers for about
5 seconds.
14. Thoroughly clean all of the drive rollers (black and white) with the
swab. While the rollers are turning, use an up-and-down motion to
clean the entire roller. You may need to use several cleaning swabs
if the rollers are very dirty.
15. Replace the top scanner cover.
NOTE: Be sure that the covers are installed in the proper positions.
Take care not to install covers at an angle. The paper path
should be clear to allow documents to transport freely through
the scanner.