Searching for channels (channel search) – Kathrein UFS 902 User Manual

Page 61

Press the

button to move to the next selection item.

Transponder Frequency

Use the

buttons (transponder frequency already saved) or the number buttons (transponder

frequency not yet saved) to select the transponder frequency on which the channel being sought
is transmitted. At the bottom right of the screen display, the receiver shows the current signal strength
and signal quality of the selected transponder.

Press the

button to move to the next selection item.

The selection items: DVB Type, FEC, Polarisation and Symbol Rate need be entered only if the
transponder has yet to be saved (see manual (channel) search).

Service ID

Using the

buttons or the number buttons, enter here the service ID of the channel being sought.

When you have made your settings, use the

buttons to select “Start Search” and press

the

button to start the search. You can cancel the search at any time by pressing the

button.

During the search you will see a display that shows you the progress of the search.

After completion of the search, you will see the following message (example):

SEARCHING FOR CHANNELS (CHANNEL SEARCH)

Press the

button. You will be asked whether you wish to save the changes or not. Selection is

performed using the

buttons and is confi rmed using the

button. If you select “Yes, save

changes”, the newly found channels will be added to the end of the channel list. Then press the

button to exit the menu. The channel list is opened on to the TV screen by pressing the

button

(see also section “On-screen displays” “Channel list TV/Radio”).