Sharp AR-M700N - Manual (Page 79)

4-3
4
PLACING ORIGINALS
■ ■ ■ ■ Using the automatic document
feeder
1 Open the document cover, make sure that
an original has not been left on the
document glass, and then gently close the
document cover.
2 Adjust the original guides to the size of the
originals.
3 Place the originals face up in the
document feeder tray.
Place the originals face
up.
Insert the originals all
the way into the
document feeder. The
stack height must not be
higher than the indicator
line (maximum of 150 pages).
■ ■ ■ ■ Using the document glass
Open the document cover, place the
original face down on the document glass,
and then gently close the document cover.
●Align the corner of the original with the tip of the
arrow mark on the document glass scale.
●Place the original in the appropriate position for its
size as shown above.
NOTE
Do not place any objects under the original size
detector, because they may damage it or the original
size may not be detected properly.
8½x11
or A4
8½x14
or B4
11x17 or A3 8½x11 or A4
Document glass scale
mark
Document glass scale
mark
NOTE
Original size detection function
One of the four groups of standard original sizes shown below can be selected for detection by the original size
detection function. The factory default setting is "INCH-1". The setting can be changed using "ORIGINAL SIZE
DETECTOR SETTING" in the key operator programs.
Group
Detectable original sizes
Document feeder tray (for reversing automatic document feeding)
Document glass
1 INCH-1
11" x 17", 8-1/2" x 14", 8-1/2" x 11",
8-1/2" x 11"R, 5-1/2" x 8-1/2"
Document glass + A4
2 INCH-2
11" x 17", 8-1/2" x 13", 8-1/2" x 11",
8-1/2" x 11"R, 5-1/2" x 8-1/2"
Document glass + A4
3 AB-1 A3, A4, A4R, A5,B4, B5, B5R Document glass + 8-1/2" x 11", 216x330
4 AB-2 A3, A4, A4R, A5,B5, B5R, 216x330 Document glass + 8-1/2" x 11", B4