Sharp AR-M700N - Manual (Page 50)

MISFEED REMOVAL
2-22
■ ■ ■ ■ Misfeed in paper tray 3
1 Remove the duplex unit.
Grasp the finger hold
and gently open the unit.
2 Remove the misfed paper.
Turn roller rotating knob
A in the direction of the
arrow to remove the
misfed paper.
3 Open the lower cover on the left side of the
machine.
Grasp the finger hold
and gently open the unit.
4 Remove the misfed paper.
Be careful not to tear the
misfed paper during
removal.
5 Close the lower cover on the left side of
the machine.
6 If misfed paper is not found in step 3, pull out
paper tray 3 and remove the misfed paper.
Pull the tray all the way
out until it stops.
Check the paper
transfer unit inside the
tray.
Be careful not to tear the
misfed paper during
removal.
7 Gently close paper tray 3.
Push the tray all the way
back in.
8 Gently close the duplex unit.
After closing, confirm
that the misfeed
message has been
cleared and the normal
display appears.
■ ■ ■ ■ Misfeed in the tray 4
To remove a misfeed in tray 4, follow the same steps as in "Misfeed in paper tray 3".
NOTE
A misfeed may occur inside the compartment, so
please check the entire compartment carefully.
Roller rotating knob A