Sharp AR-M700N - Manual (Page 62)

FINISHER AND SADDLE STITCH FINISHER
3-6
Finishing modes and finisher functions
Touch the [OUTPUT] key on the main screen of copy mode to display the screen that allows selection of sort, staple
sort, group function, centerline stapling, and the output tray.
[GROUP] key (See page 3-4.)
When Group is selected, copies will be grouped by
page.
[STAPLE SORT] key (See page 3-4.)
When Staple Sort is selected, sorted sets will be
stapled and delivered to the offset tray. (They will
not be offset stacked.) Select from three stapling
positions.
[SORT] key (See page 3-4.)
When Sort is selected, sets of copies will be
collated.
[FINISHER TRAY] key (See page 3-2.)
When the offset function is selected, output is
delivered offset to the finisher tray. (The finisher
tray is automatically selected when the staple sort
function is turned on.)
[OFFSET] key (See page 3-4.)
The offset function operates when a checkmark
appears in this key. (The offset checkmark is
automatically cleared when the staple sort function
is enabled.)
[CENTER TRAY] key
If the center tray is selected, output paper will be
delivered to the exit tray located above the main
unit.
[OK] key
Touch to close the [OUTPUT] screen and return to
the main screen.
[SADDLE STITCH] key (See page 3-5.)
This is displayed when the saddle stitch finisher is
installed, and is used to staple pages at the center
and fold them in half to create a pamphlet.
Touch this key to display the pamphlet copy
setting screen (page 5-6). (This is only possible
when a checkmark appears in the checkbox of the
[AUTOMATIC SADDLE STITCH] key operator
program (See page 12 of the key operator's
guide.))
[PUNCH] key (See page 3-5.)
This is used to punch holes in printed pages when
an optional punch module is installed.
OUTPUT
SORT
STAPLE
SORT
GROUP
FINISHER
TRAY CENTER
TRAY
OFFSET
SADDLE
STITCH
PUNCH
OK
0
1
2
3
4
5
NOTE
When a functions is selected, it is highlighted.
6
7
8
9