Sharp AR-M700N - Manual (Page 67)

FINISHER AND SADDLE STITCH FINISHER
3-11
3
Removing a misfeed
When a misfeed occurs, remove the misfed paper as explained below.
■ ■ ■ ■ General procedure for the finisher and saddle stitch finisher
1 Gently move the finisher/saddle stitch
finisher away from the machine while
pressing the button.
When an inserter is
installed, separate the
inserter from the
machine while pressing
on the inserter button.
2 Remove the misfed paper from the main
unit.
After removing the
misfed paper, perform
steps 1 and 3 on page 2-
19 to reset the machine.
3 Open the upper cover of the finisher/
saddle stitch finisher.
When an inserter is
installed, lift the tray of
the inserter.
4 Lift knob (A) (See the step 3 figure), then
remove any misfed paper.
Be careful not to tear the
misfed paper during
removal.
5 Lift knob (B) (see the illustration in step 4)
and remove any misfed paper.
Be careful not to tear the
misfed paper during
removal.
6 Remove any misfed paper from the paper
exit area.
Be careful not to tear the
misfed paper during
removal.
7 Close the upper cover of the finisher/
saddle stitch finisher.
■ ■ ■ ■ When a saddle stitch finisher is installed
8 Open the front cover of the inserter (only
when an inserter is installed).
9 Open the lower cover of the saddle stitch
finisher.
10 Open the entrance cover of the saddle
stitch unit.
(A)
(B)