Sharp AR-M700N - Manual (Page 51)

MISFEED REMOVAL
2-23
2
■ ■ ■ ■ Misfeed in the bypass tray
1 Remove the misfed paper from the bypass
tray.
Be careful not to tear the
misfed paper during
removal.
2 If you did not find a misfeed in step 1, open
the side cover and remove the misfeed.
3 Gently close the side cover.
4 Remove tray 1 - tray 2.
Grasp the finger hold
and gently open the unit.
Pull the tray all the way
out until it stops.
5 Remove the misfed paper.
Check the paper
transfer unit inside the
tray and remove any
misfed paper.
6 Gently close paper tray 1 - tray 2.
Push the tray all the way
back in.
Make sure that the
misfeed message no
longer appears (the
normal message display
should appear).
NOTE
If a misfeed occurs during printing from the bypass
tray while paper is being loaded in tray 1 - tray 2,
push tray 1 - tray 2 back in to close it, and then pull
the tray out again.