Sony Ericsson XCI-V3 - Manual (Page 17)

17
GUI application
Note
When the cycle of the input trigger is smaller than the
trigger delay value set, the image is not output
correctly. Pay attention to this fact when you set the
trigger delay value.
5 SOFTWARE TRIGGER button
This button is used to capture an image immediately
after pressing the button.
3 SAVE button
This button is used to save the currently set values.
4 CANCEL button
This button is used to cancel changes.
5 Note button
This button is used to display the trigger instruction.
6 FULL SCREEN button
This button is used to display a camera image on the
full screen.
7 ? (HELP) button
This button is used to display HELP information.
Shortcut keys
When you connect a USB keyboard with this unit, you
can use the following shortcut keys in the SHUTTER
screen:
Shortcut Applicable button
Alt + W SOFTWARE TRIGGER
Alt + S SAVE
Alt + C CANCEL
Alt + F FULL SCREEN
Alt + H HELP
When you press the Alt and S keys on the keyboard to
save, the confirmation guidance is displayed on the
screen. You can press one of the following keys to be
assigned:
ENTER: Press the ENTER key if it’s OK.
ESC:
Press the ESC key if you want to cancel.
GAIN/LUT (Look Up
Table) screen
This screen is used for setting the camera gain and
gamma.
1 GAIN up down counter
You can set the gain of this unit from the following
range in units of 1 dB:
[0 to 18] (dB)
2 LUT radio buttons
The look up table is used to change the gamma setting
of this unit.
You can select one of the following settings using a
radio button:
•
γ = 1 (OFF)
•
γ = 0.45
•
γ = 2.2
• Reverse
• Binarization
Binarization is selected for changing the look up table
to binary.
You can set the threshold within the following range of
the threshold up down counter:
[1 to 1023]
3 SAVE button
This button is used to save the currently set values.
4 CANCEL button
This button is used to cancel changes.
1
2 3 4 5
6