Set up instructions – Stamina Products 55-2065 User Manual

Page 11

SET UP INSTRUCTIONS

LEVELING:

MOVING:

GRASP HERE TO MOVE

Equipment Mat

Place the

ELITE ELLIPTICAL

STEPPER

in the area where it will be used. It is recommended that the

ELITE ELLIPTICAL

STEPPER

be placed on an equipment mat. The max. operation dimensions of

ELITE ELLIPTICAL

are approximately 52" long x 28 3/4" wide x 63" tall. (These dimensions may vary up

to one inch.) An area 4 feet wide x 7 feet long is required for safe operation of the

ELITE ELLIPTICAL

STEPPER.

Make sure that adequate space is available for access to and passage around the

ELITE

ELLIPTICAL

STEPPER.

Adjust the

LEVELING CAPS(60)

on the

REAR STABILIZER(2)

so that the

ELITE

ELLIPTICAL

STEPPER

sets on the floor without rocking. Remove and reposition the

LEVELING CAPS(60)

on the

REAR STABILIZER(2)

to level the

ELITE ELLIPTICAL

STEPPER.

The

ELITE ELLIPTICAL

STEPPER

has a pair of

MOVING WHEELS(58)

built into the

FRONT STABILIZER(3)

at the front. Grasp the center section of the

HANDLEBARS

(7, 8)

and tip the

ELITE ELLIPTICAL

STEPPER

forward to move.

FUNCTION INSPECTION:

Visually inspect the

ELITE ELLIPTICAL

STEPPER

to verify that assembly is as shown in the above

illustration. Check the function of the

ELITE ELLIPTICAL

STEPPER

. Stand on the foot pedals and

place your hands at a comfortable position on the handlebars. Slowly move your highest foot forward and
follow the natural path of the machine. Turn the crank slowly through one complete revolution to verify that
the drive train functions properly. Use the "

/ " buttons on the

COMPUTER(32)

to select a program and

verify that the Magnetic System provides different tensions. Refer to the

COMPUTER INSTRUCTIONS

on pages 13 to 21.

Locate and read the

Warning Label(117)

on the

ELITE ELLIPTICAL

STEPPER

. Make

sure that all users read the

Warning Label(117).

CAUTION: