Samsung DVD-R125 - Manual (Page 90)

90 - English
Remote Control
Read the table of contents and then
find and read the section describing
your problem, follow the instructions
given.
Turn your DVD recorder off and on.
If the problem still persists, contact a
nearby Samsung service centre.
Checkpoint 1
Checkpoint 2
Checkpoint 3
Other problems.
Point the remote control at the remote
control sensor on your DVD recorder.
Allow for proper distance. Remove
obstacles between your DVD recorder
and the remote control.
Check whether the batteries are empty.
Check for the TV/DVD selection button.
Checkpoint 1
Checkpoint 2
Checkpoint 3
The remote control doesn't work.
A recorded disc is played with only the
subtitle and the audio signal which
were selected during recording.
Checkpoint 1
Is it possible to change a subtitle and an audio
signal on a recorded disc?
Other
Press the button on the front panel of
the Recorder for more than 5 seconds with
no disc in the DVD recorder.
All settings including the password will
revert to the factory settings. Do not use
this unless absolutely
necessary. (Note that this function is
possible only when no disc is inserted.)
Checkpoint 1
I forget my password for parental supervision.
A
dditional Information
Check your TV system setup correctly.
Screen Jitter may occur when the
frame rate is converted from 50Hz to
60Hz for 720p/1080i HDMI (High
Definition Multimedia Interface) Output.
Please refer to the user’s manual of
your TV.
Checkpoint 1
Checkpoint 2
Checkpoint 3
HDMI output Jitter
00842A-R125-XEU_87~92 6/7/05 7:57 PM Page 90