Sub-Zero ICB424 - Manual (Page 23)

23
F I N I S H E D W O O D S I D E PA N E L S
Side panels for Models ICB427 and ICB427R
are not attached to the unit. You must securely
fasten the panels to adjacent cabinets and
floor.
Panels should be fastened to the floor and
walls using ‘L’ brackets (hardware not
provided). To help you move the unit into
place, rout out an area in the floor so the ‘L’
bracket will sit flush with the floor level.
Brackets and screws are provided for
mounting the unit to adjoining cabinets and
side panels. Each unit has four side-mounting
clips on each side.
IMPORTANT NOTE: For installations where
you are not attaching to a side wall, or you are
installing two Model ICB427, ICB427R or Inte-
grated units together, you must remove the
side-mounting clips before moving the unit
into position. After removing the clips, replace
the screws into the appliance.
A dual installation heater kit (#7007529) is
necessary for anchoring two Model ICB427,
ICB427R or Integrated units together. Contact
your Sub-Zero dealer for details.
L O C K I N S T A L L A T I O N
For Models ICB427 and ICB427R, the accessory
lock is attached to the decorative door panel
through a field-drilled hole in the panel. The
catch should be installed on the top of appli-
ance cabinet before the unit was moved into
position. Installation instructions are included
with the lock kit.
IMPORTANT NOTE: For accessory stainless
steel panels requiring a lock, panels must be
ordered with the lock mounting hole pre-
drilled.
9 0 - D E G R E E D O O R S TO P
Models ICB427 and ICB427R have a 90-degree
door stop built into the hinge system. Use the
blade edge of a standard screwdriver and
rotate the brass cam in the center portion of
the hinge until you reach the stop. You must
make this adjustment to both the bottom and
top hinge. Refer to illustration 15 below.
C O M P L E T I N G T H E I N S T A L L A T I O N
IMPORTANT NOTE: When you have
completed the installation of the Model ICB427
or ICB427R Wine Storage unit, refer to pages
34–35 for the Installation Checklist and Service
Information.
M O D E L S I C B 4 2 7 A N D I C B 4 2 7 R I N S T A L L A T I O N
Illus. 15
M O D E L S
I C B 4 2 7
I C B 4 2 7 R
O P T I O N A L
C O M P O N E N T S
Optional installa-
tion components
are available
through your
Sub-Zero dealer.
You can also visit
our website at
subzero.com.