Sub-Zero ICB424 - Manual (Page 22)

22
M O D E L I C B 4 2 7 R D R A W E R P A N E L S
IMPORTANT NOTE: Drawer panels for Model
ICB427R must be a minimum of 16 mm thick
and cannot exceed 5 kg for each panel.
Remove the mounting hardware provided and
set aside. You should work on the back side of
each drawer panel and you should protect the
fronts of these panels.
Position the top edge of the drawer template
flush with the top edge of each drawer. For the
top drawer, there is only one place for the
lower mounting bracket to be placed. However,
depending on the depth of the lower drawer
panel, you have two options for placement of
the bracket. Refer to illustration 13 below.
Secure the template in place with tape or small
clamps and mark positions for your pilot holes.
Remove template. Drill pilot holes and place
the hardware in the proper place (dog-ear
bracket on top) and fasten securely with the #8
x 13 mm screws provided. See illustration 14.
To help with proper placement of drawer
panels, examine the lower panel mounting
bracket and determine which slotted holes to
use. Position screws into the lower portion of
the drawer that correspond with these slotted
holes. Leave these screws out a small distance
so they can help when you mount the drawer
panels to the drawer.
With the two brackets in place on the drawer
panel, engage the top dog-ear bracket first and
then the lower bracket onto the protruding
screws. You will have a 6 mm adjustment up
and down and side to side in each drawer
panel. Fasten all screws to the lower bracket to
secure the drawer panel.
IMPORTANT NOTE: Once drawer panels have
been adjusted for proper spacing, be sure to
reconnect the control cable on the upper
drawer after you have installed the drawer.
Refer to illustration 3 on page 15.
S O L I D D O O R P A N E L S
IMPORTANT NOTE: The solid door panel for
Models ICB427 and ICB427R must be a minimum
of 16 mm thick and cannot exceed 18 kg.
Installation of the solid door panel is the same
as the door panel for a glass door model.
M O D E L S I C B 4 2 7 A N D I C B 4 2 7 R I N S T A L L A T I O N
A solid panel must not be installed on a
glass door unit, as this may cause
moisture to form behind the panel.
M O D E L S
I C B 4 2 7
I C B 4 2 7 R
P A N E L
D E S I G N
Additional panel
design information
can be found in
the Sub-Zero
Design Guide.
Check our website
at subzero.com.
Back Of
Drawer Panel
Gap On Side
Edges Will Vary
According To
Design
Top Of Template
Flush With Top Of
Drawer Panel
Illus. 13 Illus. 14