Sub-Zero ICB424 - Manual (Page 19)

19
K I C K P L AT E / G R I L L E I N S T A L L A T I O N
Once the unit is leveled and wiring connec-
tions made, the kickplate / grille can be
installed.
IMPORTANT NOTE: The kickplate / grille must
be removed for servicing. The floor cannot
interfere with removal. The louvered section of
the kickplate / grille must not be covered so as
to prevent air circulation.
For Models ICB427 and ICB427R, there is some
adjustment to the mounting assembly so that
the kickplate / grille can fit flush with the
surrounding area. Refer to illustration 9 below.
IMPORTANT NOTE: The unit must be allowed
to have ventilation through the fins of the kick-
plate / grille. You may cover the solid area, but
do not block the fins. For Model ICB427R, the
lower drawer panel may hang in front of the
fins, but your baseboard molding must not
cover them.
Turn power back on to the electrical outlet.
D O O R P A N E L S
Models ICB427 and ICB427R are available as a
glass door (G) or solid door (S) model. Each of
these Wine Storage units are set up at the job
site as either the stainless steel or integrated
design.
Classic stainless steel panels—available as
sales accessories—may be configured several
ways and are shipped separately. Stainless
steel panels are shipped with matching
handles in place.
The integrated design uses custom wood or
other decorative panels and handles provided
by the customer.
Model ICB427R requires solid panels on the
drawers that may match the door panel, or be
complementary. The Model ICB427R stainless
steel drawer panel set and stainless steel door
panel are ordered and shipped as two items.
The solid door Model ICB427S or ICB427RS—
with no glass window—requires a different
door panel than the glass door design.
Before beginning installation, check for the
correct components for the fit and finish
desired. The door and drawers (Model
ICB427R) require a decorative panel that is a
minimum 16 mm thick.
If you have questions, contact your Sub-Zero
dealer or cabinet supplier. Additional panel
information can be found in the Sub-Zero
Design Guide.
M O D E L S I C B 4 2 7 A N D I C B 4 2 7 R I N S T A L L A T I O N
Illus. 9
P A N E L
D E S I G N
Additional panel
design information
can be found in
the Sub-Zero
Design Guide.
Check our website
at subzero.com.
M O D E L S
I C B 4 2 7
I C B 4 2 7 R