Sharp Electronic Cash Register XE-A402 - Manual (Page 47)

45
Entering character codes with numeric keys on the keyboard
Numerals, letters and symbols are programmable by entering the character code and the
:
key. (If numeric
characters entry is selected, “1” is displayed on the operator display (lower line). Press the
N
key to release
it.) Set the alphanumeric character code table on the next page. By doing this, you can program characters
other than those on the key tops.
• Double-size characters can be made by entering the character code 253 or pressing the
W
key. “W” is
displayed when double-size characters entry is selected as shown in the operator display example below.
• All three digits of the character code MUST be entered (even if it starts with zero).
Operator display (Example)
To program the word “SHARP” in double-size characters
When you press an appropriate number key (job code number) and press the
P
key for text entry just after you
start programming with the
s
key, the cash register will automatically be ready for text entry.
253
:
083
:
072
:
065
:
082
:
080
:
S H A R P
PGM
01 W 065
Character code
=A PGM
01 W 02
Characters: Indicating double size character of “A”
Number of characters
programmed
Press of
253
: 065
Press of
:
Cursor
Department code, PLU code, UPC code, function number,
clerk code or logo message line number is displayed here.
(UPC code will disappear when
H , N or W is pressed.)
Characters entered are displayed here.