Woodstock W1770 - Manual (Page 53)

-51-
W1770 21" Bandsaw w/Foot Brake
SE
RV
IC
E
Replacing.Brake.Shoe
The brake shoe will need to be replaced when the pad
wears out, which depends upon how frequently the foot
brake is used. The following are indications that the brake
pad needs to be replaced: The bandsaw takes noticeably
longer to stop when the foot brake is pushed or the foot
brake makes metal-to-metal grinding sounds.
Contact Woodstock International Technical Support at
(360) 734-3482 to order the replacement brake shoe, Part
X1770536 (refer to Page.64).
Components.and.Hardware.Needed:
Replacement Brake Shoe (Part X1770536) ..................1
Tools.Needed:
Hex Wrench 5mm ...............................................1
Hex Wrench 6mm ...............................................1
Wrench 10mm ...................................................1
Wrench 17mm ...................................................1
To.replace.the.brake.shoe:
1. DISCONNECT BANDSAW FROM POWER!
2. Follow Steps.1-4.in Replacing.V-Belts on.Page.48.
3. Remove the cap screws, lock washers, and bushings
that secure the brake shoe to the brake lever, then
remove the brake shoe (see Figure.72).
4. Install a new brake shoe onto the brake lever with
the cap screws, lock washers, and bushings removed
in Step.3.
5. Reinstall the V-belts onto the pulleys, then slide the
lower wheel back onto the bearing shaft.
6. Tension the V-belts (see Tensioning.V-Belts, on Page.
48).
7. Reinstall the bandsaw blade, adjust blade tension
and tracking, then adjust the upper and lower blade
guides and support bearings as needed.
8. Close the wheel covers.
Figure.72. Brake shoe location.
Cap Screws
Brake Shoe