Woodstock W1770 - Manual (Page 18)

-16-
W1770 21" Bandsaw w/Foot Brake
SE
TU
P
The fence rail is installed upside down at the factory.
To.install.the.fence,.do.these.steps:
1. Remove the cap screws holding the rail onto the
table, and remove the rail.
2.. Flip the rail over and reinstall it with the cap screws
removed in Step.1.(see Figure.14).
3. Place the fence on the rail (Figure.15) and tighten
it securely with the hand knob. Refer to the instruc-
tions on Page.29 to calibrate the pointer.
Fence
Guide.Post.Handwheel
Insert the guide post handwheel onto the shaft, and
secure it with the cap screw on the flat of the shaft, as
shown in Figure.16.
Figure.16. Guide post handwheel
installed.
Handle
Figure.15. Installing fence onto rail.
Figure.14. Tightening guard rail cap
screws.