Shark VAC-THEN-STEAM MV2010 - Manual (Page 9)

TOLL FREE: 1-800-798-7398 5 www.SharkVacThenSteam.com
English
3 Place your foot lightly on the top
of the cleaning unit base. Tilt the
cleaning unit back. Vacuum your
floors.
IMPORTANT: Vacuum all surfaces
first before steam-cleaning to
avoid condensation build-up. Avoid
vacuuming after steam mopping.
NOTE: If you vacuum and then
steam-clean one room, before
moving on to the next, wait 10
minutes for the condensation to
clear before vacuuming again.
USING VACUUM MODE
1 Pull and twist the quick release cord
holder to unwrap the power cord
completely. Plug in the unit.
2 To vacuum, slide the toggle switch
until the vacuum power button is
exposed. Press the vacuum power
mode button to the
ON “I” position.
IMPORTANT: You cannot use the
vacuum function if the frame and
pad are attached to the base of the
cleaning unit.
NOTE: Only vacuum sealed and
non-carpeted bare floor surfaces.
Refer to floor manufacturer
guidelines and warnings.
Vacuum Mode
After inserting the telescopic handle,
your cleaning system is vacuum-ready.
Begin vacuuming your hard-surface
floors by tilting the cleaning unit back
and pressing the vacuum power button.
3
1
2
MV2010_11_IB_ENG_110103.indd 5 11-01-03 1:26 PM