Shark VAC-THEN-STEAM MV2010 - Manual (Page 17)

TOLL FREE: 1-800-798-7398 13 www.SharkVacThenSteam.com
English
POST-MOTOR FILTER
1 Twist the Shark ® logo knob on the
post-motor cover counter-clockwise
to release cover.
2 Use both hands to grip cover on both
sides and pull cover toward you.
Gently peel the filter off the inside of
the cover. Thoroughly rinse the filter
in lukewarm water. Squeeze out any
excess water. Air dry for 24 hours
before reusing.
3 Insert a dry filter into the inside of
the cover. Snap cover onto the
Vac-Then-Steam™.
Twist the Shark ® logo knob clockwise
to secure cover.
NOTE: Using only water, thoroughly
rinse filter every 3 months and dry
for 24 hours. Replace filter in the
Vac-Then-Steam™ once a year. More
regular filter care or replacement
may be required with excessive use.
DO NOT use a hair dryer or any other
forced hot air to dry any of the filters.
NOTE: Any other servicing should be
performed by an authorized service
representative
ORDERING REPLACEMENT PARTS
Go to www.SharkVacThenSteam.com
to find replacement filters,
accessories, and micro-fiber pads.
2
1
3
A replacement post-motor
filter has been provided
with your product. Use the
replacement filter while the
other is drying.
MV2010_11_IB_ENG_110103.indd 13 11-01-03 1:26 PM