Shark VAC-THEN-STEAM MV2010 - Manual (Page 8)

4 TOLL FREE: 1-800-798-7398
Getting Started: Vacuum and Steam Panel
OPERATING IN VACUUM MODE:
1 Remove steam pad and frame,
if attached. See page 8 for
instructions. Vacuum will not activate
if steam frame is attached.
2 SLIDE THE TOGGLE SWITCH UP to
expose the vacuum power button.
3 Press the VACUUM POWER BUTTON
to the ON “I” position to activate
the vacuum.
OPERATING IN STEAM MODE:
1 Attach steam pad and frame.
Steam mode will not work if the pad
and frame are NOT attached. See
page 8 for assembly instructions.
2 Fill the water tank.
SLIDE THE TOGGLE SWITCH DOWN
to expose the Steam Power button
3 Press the STEAM POWER BUTTON
to the ON “I” position. The button
will be illuminated red when steam
mode is activated.
4 Wait 30 seconds to heat water, then
TILT HANDLE BACK TO ACTIVATE
STEAM PUMP.
The Vac-Then-Steam™ has two
operating modes:
1
2
3
VACUUM MODE:
STEAM MODE:
1
2
3
DO NOT USE STEAM PAD AND
FRAME IN VACUUM MODE
MV2010_11_IB_ENG_110103.indd 4 11-01-03 1:26 PM