Parts names – Sanyo VCC-5984 User Manual

Page 7

PARTS NAMES

Lens iris output connector (LENS)

This 4-pin connector is used to send the DC control signal and power supply to an auto-iris type lens.

Camera setup section (under the cover)

These settings are for when using a 1/3 inch CS mount

DC (without EE internal amplifier) type lens. However,

if due to installation conditions or environment the settings may need to be modified for best results (see
"

SETTINGS"). To access the controls, remove the cover fixing screw, then remove the cover.

NOTE: When using a 1/2 or 2/3 inch C mount VIDEO (with EE internal amplifier) auto-iris type lens, set the

A.I. LENS switch to the VIDEO position.

L53H4/US2 (VCC-5984) GB 2003, 1, 7

English