Spectrum Brands SPECTRUM PLUS SP-550 - Manual (Page 35)

To Program Speed Dial Locations
1. Press and hold the “STORE” key for 6 seconds to
activate Administrator mode. The words “ENTER
ACCESS NO.” will appear (figure 1).
2. Next, press the speed dial location key where the
desired location will be. The display will read
“Mxx NO CONTENT”. If the display shows a
record, then there is a stored name and number in
that location (figure 2).
3. Press the “STORE” key again and the display will
read “ENTER NUMBER” (figure 3).
4. Using the dial pad, enter the number. Note that the
local area code is not required if AREA CODE is
pre-programmed into memory.
5. After entering the number, press the “STORE”
key. The display will read “ENTER
NAME” (figure 4).
6. Using the keypad, enter the name associated with
the number being programmed and include the
Flash, and/or Pause, when needed.
7. Press the “STORE” key to store the entry.
8. Program other speed dial locations, repeat 2 to 7.
9. To exit the program mode, press “DISC”.
Programming Procedure for SpectrumPlus tm Speed Dial Features
(Administrator Programmable Only) (Manual Entry of Characters)
The SpectrumPLUS TM Telephone has 11 one-touch speed dial locations that are convenient for
dialing frequently used telephone numbers. This feature is under Administrative control so user
changes do not occur.
?
Speed dial programming must be done with the telephone plugged into the telephone line and power
adapter.
?
Programming can be performed with the telephone on-hook only.
?
A maximum of 32 digits can be entered into ENTER NUMBER and 12 characters into ENTER
NAME.
ENTER NUMBER
ENTER NAME
Set up speed dial memory
locations with name and
number entries. Check
verifies correct entry.
34
ENTER ACCESS NO.
12/01
PM
M01 NO CONTENT
12/01
PM
ENTER NUMBER
12/01
PM
ENTER NAME
12/01
PM
Figure 2
Figure 3
Figure 4
Figure 1