Spectrum Brands SPECTRUM PLUS SP-550 - Manual (Page 19)

Connecting the Handset Cord
A 10 foot modular coil handset cord is
provided. (Be sure that the wall/desk eleva-
tion stand has not been attached). To install
the cord, simply plug the short end of the
handset cord into the modular jack on the
handset. The long end of the handset cord
plugs into the jack labeled “Handset” located
on the bottom of the SpectrumPLUS
TM base
unit. Place the line cord into the line cord
channel located directly below the jack.
Installing the Keycaps
Twenty-two preprinted named feature
keycaps are provided to identify the speed
dial key.
There are 11 clear keycaps already installed.
To install pre-printed keys, remove the clear
keycap by simply pulling up. Replace with
the preprinted keycaps or place hand written
paper index sheets under a clear keycap.
Program each speed dial key for the specific
function of the key.
For speed dial programming instructions, see the section on “Programming Procedure For
SpectrumPlus
tm Speed Dial Features” in this manual.
There are 4 additional clear keycaps and 2 index sheets provided as spares. Use these for your
own personal speed dial identities. Write the speed dial name on the blank speed dial index
cards and insert into the blank keycaps. Place the keycap on the correct memory speed dial
location. (see index sheets provided in box)
.
18
The twenty-two preprinted keycaps are described below:
Call Fwd On Call Back Paging Skip Msg Information
Call Fwd Off Cancel Call Back Ring Again FF Msg 911
Transfer Call Park Save Msg Rew Msg
Conf Call Pick-up Del Msg Emergency
DND Group Call Pic k-up Rpt Msg Help Desk
PLASTIC KEYTOP
PLASTIC TOP CABINET
CLEAR "SNAP-ON" KEY CAP
PLASTIC TOP CABINET
OR SILK SCREEN KEY CAP