Troubleshooting continued, Problem cause correction poor cut - uneven, Battery will not charge – Swisher ZT2560 User Manual
Page 36: Loss of drive
TROUBLESHOOTING Continued
PROBLEM CAUSE CORRECTION
Poor cut -
uneven
1.
Worn, bent or loose blade
2.
Mower deck not level
3.
Buildup of grass, leaves and trash under
deck.
4.
Bent deck
5.
Faulty Blade driver assembly
1.
Replace blade. Tighten blade bolt
2.
Level deck. See section in this manual
3.
Clean underside of mower deck
4.
Replace deck
5.
Replace blade driver assembly
Battery will
not charge
1.
Bad battery
2.
Poor cable connections
3.
Faulty solenoid
1.
Replace battery
2.
Check/clean all connections. See section
in this manual
3.
Replace solenoid
Loss of drive
1.
Bypass linkages in the bypass position
2.
Hydro belt worn, damaged, or broken
3.
Idler spring loose or broken
1.
Make sure that the bypass linkages are in
the drive or engaged position. Located at
the rear of the machine. Refer to decal
on the rear of the unit.
2.
Replace Hydro belt.
3.
Replace Idler spring
36
36