SEH Computertechnik ISD300 - Manual (Page 16)

ISD300 User Manual
ISD300 User Manual
Network Settings
16
3. Enter the Host name (max. 256 characters).
4. Click Set.
How to set Date and Time?
Date and time specifications are necessary if you want to display
the time at which the print job was printed. Date and time
specifications are displayed in the Job History.
Date and time can be entered manually during the Quick Setup
also; see: How to configure via Quick Setup? on page 17.
Date and time can be adjusted manually or obtained from a time
server.
If you use a time server, the manually entered time will be
overwritten by the time provided by the time server.
Proceed as follows:
1. Click Configuration.
2. Click Board Settings.
3. Enter time and date or use a time server; see Table: Parameter
Settings - Board.
4. Click Set.
Table: Parameter Settings - Board
Parameter Description
Default name Default name of the ISD300 set by the manufacturer
Host name Host name of the ISD300 set by the administrator
(max. 256 characters)
Date Date in the format: dd.mm.yyyy (e.g. 23.05.2004)
Time Time in the format: hh:mm (e.g. 16:36)
Time server IP address or the host name of the time server
(e.g. ’ntp1.ptb.de’) The ’ntp’ protocol is used.