Shindaiwa 502s - Manual (Page 7)

7
Prior to assembly
WARNING!
Do not make unauthorized
modifications to this saw, guide bar,
or chain!
IMPORTANT!
The operational procedures described in
this manual are intended to help you get
the most from this unit and also to protect
you and others from harm. These proce-
dures are general guidelines only, and are
not intended to replace any additional safety
rules or laws that may be in force in your
area. If you have any questions regard-
ing your Shindaiwa chain saw, or if you do
not understand something in this manual,
your Shindaiwa dealer will be glad to assist
you. For additional information, you may
also contact Shindaiwa Inc. at the address
printed on the back of this manual.
Assembly and Adjustments
Before assembling, make sure you
have all the components required for a
complete unit:
Spark plug/13 mm socket wrench
■
(Scrench)
Carefully inspect all components for
damage.
Installing and Adjusting the Guide Bar and Saw Chain
CAUTION!
Failure to align the guide bar and chain
tensioner pin can cause serious dam-
age to the clutch cover, guide bar, ten-
sioner pin, and/or engine crankcase!
Guide Bar
Spacer (discard)
Nuts
Studs
Clutch Cover
NOTE:
For longest chain life, place new or
replacement chain loops in oil and soak
overnight before installation.
IMPORTANT!
The chain brake must be completely dis-
engaged before removing or installing
the clutch cover.
Use the socket wrench to remove the 1.
clutch cover nut(s) in a counter- clock-
wise rotation.
Remove the clutch cover.
2.
Remove and discard the packing spacer. 3.
Place the guide bar over the guide bar 4.
stud(s) and chain tensioner pin.