Sanyo CLT-D5880 - Manual (Page 51)

E49
ADDITIONAL
INFORMATION
The digital security code is an identification code used to connect the handset
and the base unit. Normally, setting the code is not necessary. In the rare
situation that you suspect another cordless telephone is using the same
security code, you can change the code. To change the digital security code:
1
In standby mode, select Deregister HS in the menu and press the
OK soft key. Deregister HS? appears.
2
Press VOL/ ▲ to select Yes and then the OK soft key.
When de-registration is complete you will hear a confirmation tone,
and
Deregistration Complete appears.
3
After de-registering the handset, place the handset to the base to register.
You must re-register the handset before you can use it.
Changing the Digital Security Code
• If the battery pack is completely drained, the handset will not beep when paging.
Note:
To locate the handset, press PAGE on the base when the phone is in standby
mode. All registered handsets beep for 60 seconds, and Paging appears on
the handset display. To cancel paging, press any key on the handset or PAGE
on the base.
Find Handset
UP800DH(CLT-D5880) OM 1/24/06 3:39 PM Page 49