Sanyo CLT-D5880 - Manual (Page 34)

E32
DIRECTORY
• When the memory is full, you will hear a beep and Memory Full appears. You cannot
store names and numbers.
• The pause key counts as one digit. Pressing the PAUSE soft key more than once
increases the length of the pause between numbers. Each pause represents a 2 second
delay.
• If you choose not to store a Distinctive Ring, simply select the "No Selectn" option.
• If you choose not to store the name/number as a Speed Dial, simply choose the
"No Selectn" option.
• Selecting a speed dial location where a number is already stored releases the old
number's speed dial setting. The new number will be stored in the speed dial location.
Notes:
6
Distinctive Ring appears. Press VOL/ ▲ or VOL/▼
to move the pointer to one of the Distinctive Ring
options and then press the OK soft key.
7
Speed Dial appears. Press VOL/ ▲ or VOL/▼ to
move the pointer to select the Speed dial location
(10 locations: SPD1-SPD0).
8
Press the OK soft key. You will hear a confirmation
tone, and
Done! appears in the display.
D i s t i n c t i v e R i n g
N o S e l e c t n
F l i c k e r
BACK D E L E T E OK
S p e e d D i a l
N o S e l e c t n
S P D 1 : < E m p t y >
BACK D E L E T E OK
M o v i e s
8 0 0 - 7 3 0 - 3 4 5 6
B e e t h o v e n 9 / S P D 1
BACK DELETE EDIT
The memory locations in the handset are not limited to phone numbers.
You can also store a group of numbers (up to 20 digits) that you need to enter
once your call connects. This is referred to as Chain Dialing.
An example of this is a bank account number. Store the account number in
one of the phonebook locations (refer to "Phonebook (Storing Phone
Numbers, Names, Distinctive Rings and Speed Dial)" on page E31). When you
call your bank and are prompted to enter the account number, scroll through
your phonebook locations until you find your account number, and then press
the DIAL soft key.
Chain Dialing
UP800DH(CLT-D5880) OM 1/24/06 3:39 PM Page 32