Sanyo CLT-D5880 - Manual (Page 45)

E43
CALLER ID
FEATURES
Calling a party from the Caller ID list
Standby Mode
1
When the phone is in standby mode, select the
Caller ID message (see "Viewing the Caller ID List"
on page E41).
2
To have the phone dial a "1" before the displayed Caller ID number,
press
/TONE/ . To have the phone dial the stored area code before
the displayed Caller ID number, press #/ .
3
Press TALK/FLASH or SPEAKER. The displayed phone number dials
automatically.
Talk Mode
1
When the phone is in talk mode, select the Caller ID message you want to
dial (see "Viewing the Caller ID List" on page E41).
2
Press the DIAL soft key, and the number will be dialed.
Storing Caller ID messages in the Phonebook
Messages shown in the Caller ID list can be stored in the phonebook.
The phone number and name of the party on the Caller ID list can be stored
in memory.
1
When the phone is in standby mode, select the Caller ID message to be
stored.
Then press the STORE soft key. Store/Edit Name appears. If the Caller ID
message is already stored in memory, you will hear a beep and This
data is already stored!! appears. The number will not be stored.
2
To complete the setting, follow the steps 3-8 in "Phonebook (Storing
Phone Numbers, Names, Distinctive Rings, and Speed dial)" on page E31.
Using the Caller ID Message List
1 2 / 2 1 1 2 : 3 0 P M
J a n e S m i t h
2 1 4 - 5 5 5 - 1 2 3 4
BACK DELETE STORE
UP800DH(CLT-D5880) OM 1/24/06 3:39 PM Page 43