Sanyo CLT-D5880 - Manual (Page 25)

E23
USING
THE INTERFACE
Setting Voice Mail Tone
Voice Mail Tone sets the voice mail tone. If your service does not support SDT
message signal, set your VMWI (Visual Message Waiting Indicator) not to
detect SDT message signal.
1
Press MENU soft key. Select the Global Setup menu,
and then the Voice Mail Tone Submenu.
2
Press VOL/ ▲ or VOL/▼ to set the voice message
indication (SDT message signal) to On or Off .
3
Press the OK soft key. You will hear a confirmation tone.
De-register the Handset
Deregister HS clears the handset's ID from the main base unit or the base ID
from the handset. You will usually only deregister the handset if you are
having a problem with your phone or if you need to change the digital
security code. (see page E49).
1
In standby mode, select Deregister HS in the menu
and press the OK soft key.
Deregister HS? appears.
2
Press VOL/ ▲ to select Yes and then the OK soft key.
When de-registration is complete you will hear a confirmation tone,
and
Deregistration Complete appears.
3
After de-registering the handset, place the handset to the base to register.
You must re-register the handset before you can use it.
V o i c e M a i l T o n e
O n
O f f
BACK D E L E T E OK
D e r e g i s t e r H S ?
Y e s
N o
BACK D E L E T E OK
UP800DH(CLT-D5880) OM 1/24/06 3:38 PM Page 23