Sunwave Tech. SRC-2200 - Manual (Page 14)

Code Setup
This section explains how to use the SRC-2200’s learning function to learn the infrared
codes of another remote control.
Read the following reminders before proceeding to operate the learning function.
Reminder 1:
The SRC-2200's learning eye must be kept in a
straight line with the transmitter of the original
remote control at a distance between 2 and 4
inches (approximately 5-10cm).
Reminder 2:
During learning, keep pressing each learning key
of the original remote until a “
√” appears and two
beeps are heard; then release the learning key.
If an “X” mark appears, repeat the operation.
If desired, you can directly reassign codes to keys
with the learning function which will replace the
original codes automatically.
A key with mark means the key already has a
learned code.
Reminder 3:
Except for the pre-setup of
MCE/XBOX /PS2 device codes,
which they can not be learned by
SRC-2200, all the other keys for
other devices can be learned by
using the learning function.
13